Custom metal fabrication in Utah

New brackets, small frames, covers and plates made in our shop from your drawing, a sketch with sizes, or the worn part you want copied.

Small steel machine base frame of square tube clamped square on a fixture table with a square and tape measure

Sometimes a repair is not the answer and you need a new part. Custom metal fabrication is how we make it: we cut the material, bend and drill it, join the pieces, and finish the part so it is ready for your team to fit. The part can come from a full drawing, a sketch on paper with the key sizes, or a worn original that we measure and copy.

Our fabrication work is sized for small and medium parts. Equipment brackets, small machine bases and frames, covers and guards, mounting plates, store fixture parts and sign frames are typical. Everything is built in our shop and handed back to you for fitting.

What we make

  1. Brackets and mounts

    Angle, plate and bent brackets for equipment, fixtures, signs and shelving.

  2. Small frames and bases

    Square tube and angle frames that hold a machine, a cabinet or a display.

  3. Covers and guards

    Sheet steel and aluminum covers that close off a moving part or a messy corner.

  4. Mounting plates

    Flat plates with the bolt pattern you need, cut, drilled and edges broken.

  5. Copies of worn parts

    A new part made from your old one, with the worn areas corrected.

  6. Fixture and sign frames

    Steel frames for store fixtures and sign faces, made to your sizes.

From drawing to part

  1. Review the drawing

    We read your drawing, sketch or sample and ask about anything that is not clear before quoting.

  2. Written quote

    Material, sizes, finish and the number of parts go into a written quote for you to approve.

  3. First piece

    We make the first part and show it to you, so you can check the fit before the rest are made.

  4. Run and hand back

    The remaining parts are made to match the approved piece, then packed for pickup.

Making a new part from an old one

Copying a part is one of the most common things we do. You bring the old part, worn or broken, and we measure it, work out the original shape and sizes, and make a new one. Where the old part has worn, we make the new one to the size it should have been, not the size it became. If something on the original looks like a weak spot, we point it out and suggest a small change.

For parts that will be made again later, we keep the measurements and notes from the first job. That way a repeat order next year starts from what we already know, and the new parts match the ones you already have.

Custom metal fabrication: questions

Something else on your mind? Call the shop at (775) 678-1312.

What kind of drawing do you need?

A drawing helps, but a clear sketch with sizes or the original part is often enough to start.

Can you make just one part?

Yes. One-off parts are a normal job for us, as are small batches and repeat runs of the same part.

Which materials do you work with?

Mild steel, stainless steel and aluminum in sheet, plate, bar, angle and tube.

Who fits the finished part?

We hand the finished part to you, packed and tagged, and your own team fits it.

Get help with custom metal fabrication

Send the request with a short description of the part. We follow up during shop hours and ask for photos or drawings by email.