Metal drilling services in Utah

Hole patterns, countersinks and tapped holes drilled in bars, plates and brackets, including holes in the right place on repaired parts.

Floor drill press with a flat steel bar held in a vise, a row of center punch marks and bright chips on the table

A part with holes in the wrong place does not fit, however good the rest of it is. Metal drilling services in our shop cover the hole work other businesses send out: bolt patterns in plates, rows of holes in flat bar, countersunk holes for flush screws, tapped holes for bolts, and new holes in parts we have just repaired.

Holes are laid out from your drawing, from a mating part, or from a sample you send. For batches we set up a stop or a simple jig so every part gets its holes in the same place. Each part is deburred after drilling so it is clean to handle and ready to bolt up.

Typical hole work

  1. Bolt patterns

    Patterns for base plates, brackets and mounting plates, laid out and drilled.

  2. Rows of holes

    Evenly spaced holes in flat bar and angle for shelving and fixtures.

  3. Countersinks

    Countersunk holes so screws sit flush with the surface.

  4. Tapped holes

    Threads cut in plates and bars so bolts go straight in without a nut.

  5. Matching a mating part

    Holes transferred from an existing part so the new one lines up.

  6. Redrilling repairs

    Fresh holes in rebuilt areas of repaired parts.

How hole work runs

  1. Layout source

    You send a drawing, a mating part or a sample showing where the holes go.

  2. Quote in writing

    Hole sizes, threads, quantity and finish are written into the quote.

  3. First part check

    The first part is drilled and checked against the drawing or the mating part.

  4. Batch and deburr

    The rest are drilled with the same setup, deburred and packed.

Getting the holes in the right place

The most reliable way to get holes right is to send the part they have to line up with. If that is not possible, a drawing with the hole sizes and the distances from one edge works well. Tell us which edge the measurements start from, and whether any holes are threaded.

For repeat parts, we keep the setup notes from the first run so the next batch matches. If the holes are going into parts we have also cut or fabricated, we plan the drilling into the same job so the parts come back to you complete.

Metal drilling services: questions

Something else on your mind? Call the shop at (775) 678-1312.

Can you drill holes in parts we bring in?

Yes. You can bring finished or partly finished parts and we drill them to your layout.

Do you tap threads?

Yes. We cut threads in plates, bars and brackets, in common inch and metric sizes.

Can you drill stainless?

Yes. Stainless is drilled slowly with sharp bits and plenty of coolant so it does not harden.

How do you keep a batch consistent?

We set up a stop or a simple jig after the first part is checked, so every part matches it.

Get help with metal drilling services

Send the request with a short description of the part. We follow up during shop hours and ask for photos or drawings by email.