New metal parts made to order in Utah

When the old part is gone or never existed: cut, drilled and fabricated in our shop from your drawing, sketch or sample.

Freshly cut and drilled steel blanks laid out on a layout table with a square and calipers

Not every job starts with a broken part. Sometimes you need a bracket that was never made, a cover for a machine you built yourself, or ten copies of a mounting plate that wore out years ago. Our Make new services turn a drawing, a sketch with sizes or an old part into new metal parts.

The three services build on each other. Cutting gives you clean blanks to size. Drilling puts the holes where they belong. Custom fabrication bends, joins and finishes pieces into a complete part. You can order any one step, or have us carry the job all the way through.

Small steel machine base frame of square tube clamped square on a fixture table with a square and tape measure

Custom metal fabrication

New brackets, small frames, covers and plates made in our shop from your drawing, a sketch with sizes, or the worn part you want copied.

  • Brackets and mounts. Angle, plate and bent brackets for equipment, fixtures, signs and shelving.
  • Small frames and bases. Square tube and angle frames that hold a machine, a cabinet or a display.
  • Covers and guards. Sheet steel and aluminum covers that close off a moving part or a messy corner.
Custom metal fabrication in Utah
Grey band saw cutting square steel tube with a stack of freshly cut pieces on a cart beside it

Metal cutting services

Bar, tube, angle, sheet and plate cut to length and to size in our shop, from a single blank to a full order of matching pieces.

  • Bar and flat bar. Round, square and flat bar cut to length, single pieces or full bundles.
  • Tube and angle. Square and rectangular tube and angle cut square or at an angle for frames.
  • Sheet to size. Steel, stainless and aluminum sheet cut into panels and blanks.
Metal cutting services in Utah
Floor drill press with a flat steel bar held in a vise, a row of center punch marks and bright chips on the table

Metal drilling services

Hole patterns, countersinks and tapped holes drilled in bars, plates and brackets, including holes in the right place on repaired parts.

  • Bolt patterns. Patterns for base plates, brackets and mounting plates, laid out and drilled.
  • Rows of holes. Evenly spaced holes in flat bar and angle for shelving and fixtures.
  • Countersinks. Countersunk holes so screws sit flush with the surface.
Metal drilling services in Utah

Where to start

  1. You need a complete part

    Start with custom metal fabrication. We take it from drawing or sample to a finished part.

  2. You need stock cut to size

    Start with metal cutting services. Bar, tube, angle, sheet and plate cut to your list.

  3. You need holes in parts

    Start with metal drilling services. Bolt patterns, countersinks and tapped holes.

Starting from an old part

You do not need a drawing to get a new part made. Bring the worn or broken original, tell us what it does and what it bolts to, and we measure it and work out the sizes. If something on the old part caused it to fail, we suggest a small change before we cut any metal.

Have a drawing or an old part?

Either one is enough to start. Send the request, then email the drawing or photos, and we will come back with questions and a written quote.