Metal repair and restoration for business in Utah

Three ways we bring tired metal parts back: fix what broke, restore what aged, and grind what is rough.

Shelf of worn steel parts with blank paper tags waiting for repair

The parts that keep a business running take a beating. Brackets crack, covers get bent, holes wear oval, handles rust and plates collect scale. Before you order a new part, or before you find out nobody makes it anymore, there is often a simpler path: bring the old one to our shop.

Our repair and restore work is split into three services, but most jobs use more than one. A cracked bracket is repaired, then the repair is ground smooth. A set of rusty handles is restored, which means cleaning, straightening and grinding. We plan the whole job with you and quote it as one.

Grey steel guard cover with a cracked mounting tab held in a bench vise while a gloved hand marks the crack

Commercial metal repair

Cracked tabs, bent covers and worn mounting holes on the metal parts your business relies on, repaired at our bench and handed back ready to bolt on again.

  • Cracked tabs and ears. Mounting tabs that split at the bend or around a bolt hole are cut back to sound metal and rebuilt.
  • Bent covers and guards. Sheet and plate covers that took a knock are straightened on the press and checked against a flat table.
  • Torn or stretched holes. Holes that have gone oval are filled, dressed and drilled again in the right place.
Commercial metal repair in Utah
Row of old steel handles and small brackets on a bench, rusty on the left and cleaned to satin metal on the right

Metal parts restoration

Old handles, levers, plates and brackets that are rusty, scaled or out of shape, cleaned and refinished by hand and machine so they can work again.

  • Machine handles and levers. Cleaned, straightened and dressed so they sit comfortably in the hand again.
  • Steel fixture brackets. Sets of brackets restored together so they still match each other.
  • Mounting and base plates. Rust removed, faces flattened and old holes cleaned up or redrilled.
Metal parts restoration in Utah
Shop worker seen from behind with a lowered face shield grinding a steel plate edge as orange sparks fly

Metal grinding services

Edges, faces, weld beads and burrs ground clean and even on steel, stainless and aluminum parts, one at a time or as a full batch.

  • Cut edge cleanup. Sharp, rough or scaled edges on sheet, plate and bar ground even and safe to handle.
  • Weld bead blending. Beads taken down flush or blended to a smooth radius so the joint disappears under paint.
  • Flat faces. Mounting faces ground flat so a bracket or plate sits square without rocking.
Metal grinding services in Utah

Which one fits your part

  1. The part is broken, cracked or bent

    Start with commercial metal repair. We rebuild the damaged area so the part fits and works again.

  2. The part is old, rusty or worn all over

    Start with metal parts restoration. We clean the whole part to bare metal and bring it back to shape.

  3. The part works but is rough or sharp

    Start with metal grinding services. We clean edges, blend welds and flatten faces.

When repair is not the right call

Sometimes the honest answer is a new part. If the metal around the damage is too thin, or the part has failed many times in the same place, we will tell you and show you what a new part made from your old one would involve. That work runs through our Make new services, and the quote can show both options side by side.

Not sure which one?

Answer four questions about the part. The intake card suggests a service, lists what to send and carries it all into the form.

What is the part?
What happened to it?
Do you have a drawing?
How many do you need?

Bring the old part in

A broken or worn part is usually the clearest place to start. Send photos first if you like, and we will tell you what we see.