Metal cutting services in Utah
Bar, tube, angle, sheet and plate cut to length and to size in our shop, from a single blank to a full order of matching pieces.

Clean, square cuts make every step after them easier. Metal cutting services at Simper Metal Worx cover the cuts other shops and businesses need but would rather not make themselves: stock cut to length on the band saw, sheet sheared or cut to size, plate cut to shapes, and blanks prepared for the next step of your own work.
Cut pieces leave our shop with the edges deburred and the pieces counted and bundled the way you asked. If the cut parts are going on to drilling, bending or fabrication, we can carry them through those steps too, so you get finished parts instead of blanks.
What we cut
Bar and flat bar
Round, square and flat bar cut to length, single pieces or full bundles.
Tube and angle
Square and rectangular tube and angle cut square or at an angle for frames.
Sheet to size
Steel, stainless and aluminum sheet cut into panels and blanks.
Plate shapes
Plate cut into simple shapes such as gussets, base plates and tabs.
Mitered pieces
Angled cuts for picture frame corners on fixture and sign frames.
Repair blanks
Material cut to rebuild a damaged part in our repair work.
How a cutting order runs
Cut list
You send a list of lengths and sizes, a drawing, or a sample piece to match.
Quote in writing
We confirm material, sizes, quantity and edge finish in a written quote.
First cut check
The first piece of each size is measured before the rest of the order is cut.
Deburr and bundle
Pieces are deburred, counted, bundled by size and tagged for pickup.
Cut lists that work
The cleanest cutting orders start with a simple list: material, size of the stock, length or size of each piece, and how many. Note whether any pieces are cut at an angle and which way the angles face. If you are not sure how to write it, send a sketch or a sample and we will build the list with you before quoting.
Tell us how close the sizes need to be. Some pieces only need to be about right, others must match a drawing closely, and we will confirm the tolerances in the quote so there are no surprises when the parts arrive at your bench.
Metal cutting services: questions
Something else on your mind? Call the shop at (775) 678-1312.
Can you cut material we supply?
Yes. You can bring your own stock, or we can order material for the job. Either way it is noted in the quote.
Do you cut to a drawing?
Yes. Send the drawing and we will turn it into a cut list and confirm it with you first.
How are the cut edges finished?
Cut pieces are deburred before they are bundled, unless you ask for raw edges.
Can you cut angles for frames?
Yes. Mitered and angled cuts for frames are common work on our band saw.
Get help with metal cutting services
Send the request with a short description of the part. We follow up during shop hours and ask for photos or drawings by email.

