Repair intake guide for metal parts in Utah
What to tell us, what to send and how to pack a part, so the quote is clear and the work starts on the right foot.

A good repair starts before the part reaches our bench. The more we know about what the part is, what happened to it and how it fits, the faster we can tell you what we can do and put it in a written quote. This guide walks through the four questions our intake asks, what to send for each answer, and how to pack a part so it arrives in the condition it left you.
You do not have to have every answer. Many parts arrive with nothing more than a company name and a phone number taped to them, and we work it out together. But each piece of information below saves a phone call and gets you a clearer quote.
What the part is
Tell us what the part does and what it attaches to. A bracket that holds a motor needs different care than a bracket that holds a sign. If the part has a name in your shop, or a part number stamped on it, include that too.
Photos are the easiest way to explain this. Take one of the part on its own, and one or two showing where it was mounted, with the bolts and the parts around it in view.
What happened to it
Describe the damage in plain words: cracked at the bend, bent after a hit, holes worn oval, rusted through at the bottom edge. Tell us if this is the first time or if the same part keeps failing.
A part that keeps breaking usually has a cause nearby, such as vibration, a missing support or an overloaded mount. Your description of how the part is used is how we find that cause and plan a repair that lasts.
Drawings, sketches and samples
A drawing is the clearest start for a new or copied part. If you do not have one, a sketch on paper with the main sizes is fine: overall length and width, thickness, hole sizes and the distance from one edge to each hole.
If you have nothing on paper, the old part or a matching part does the same job. Without a part or a drawing, send photos with a tape measure in the shot and we will call you to talk through the rest. Please send drawings and photos by email after you submit the form.
How many and how soon
Tell us whether you need one part, a few, a batch or a repeat run you will order again. Quantity changes how we set up the work: one part is made by hand, a batch gets a stop or a simple jig so every part matches.
Let us know your timeline too. We plan the work around what you tell us and confirm the dates with you in the quote.
Try the intake
Pick the answers that fit your part. The intake card shows what to send and what happens next, and carries everything into the request form.
Packing a part for the shop
Whether you drop it off or ship it, a part that arrives clean, complete and labeled gets looked at sooner and quoted more clearly.
- Remove loose grease and dirt if you can, so we can see the damage clearly
- Keep broken pieces together in one bag, even small chips and fragments
- Tape a note with your company name, contact name and phone to the part
- Wrap finished faces and threads so they do not get dinged in the box
- Group matching parts as a set, and say how many are in the set
- Bring the mating part along if the fit is tight
Intake questions
Still unsure what to send? Email [email protected] with a photo and we will tell you.
Can I drop a part off without calling first?
Yes, during shop hours. A quick call or email ahead of time helps us make sure someone is free to look at it with you.
Can you work from photos alone?
Photos are enough for a first answer and a rough plan. For the quote itself we usually need the part, a sample or a drawing.
Do you need the part cleaned?
Loose grease and dirt off is helpful. Leave the damage as it is, because a crack or bend tells us a lot about the cause.
What if the part is too big to bring in?
Send photos and sizes first. If it fits on our benches and can be handled safely, we will tell you how to get it to the shop.
Ready to send the part?
Fill in the request form, then email the drawing or photos. We read every request during shop hours.