Metal parts restoration in Utah

Old handles, levers, plates and brackets that are rusty, scaled or out of shape, cleaned and refinished by hand and machine so they can work again.

Row of old steel handles and small brackets on a bench, rusty on the left and cleaned to satin metal on the right

Some parts are worth keeping because nothing new fits quite the same. An original lever on a shop machine, a set of steel brackets from an old store fixture, a plate that carries a bolt pattern nobody has a drawing for. Metal parts restoration is the slow, careful version of repair: we bring the whole part back, not just one broken spot.

Restoration in our shop is mechanical. We use wire wheels, abrasive discs, files, belts and hand tools to take off rust, scale and old flaking finish, then straighten what has bent and rebuild edges and holes that have worn. The result is clean bare metal ready for your own paint or finish, or a brushed or satin surface if the part is staying bare.

Parts that come back to life

  1. Machine handles and levers

    Cleaned, straightened and dressed so they sit comfortably in the hand again.

  2. Steel fixture brackets

    Sets of brackets restored together so they still match each other.

  3. Mounting and base plates

    Rust removed, faces flattened and old holes cleaned up or redrilled.

  4. Covers and small panels

    Dents eased out, edges trued and surfaces brought to an even finish.

  5. Hinges and latches

    Freed up, cleaned and refitted so they move without binding.

  6. Shop tooling parts

    Clamps, stops and jig parts brought back to clean, usable shape.

How restoration runs

  1. Sort and record

    We note every part, photograph its condition and agree with you on which ones are worth restoring.

  2. Clean to bare metal

    Rust, scale and old finish come off by wire wheel, abrasive disc, belt and hand tools.

  3. Straighten and rebuild

    Bent areas are straightened, worn edges and holes are rebuilt and dressed back to shape.

  4. Finish and hand back

    Parts get the finish you chose, from ready for paint to brushed, and are packed for pickup.

Keeping a set together

When several matching parts come in, such as a run of shelf brackets or four handles from the same machine, we keep them as a set from start to finish. Each part gets a tag, the same finish and the same attention, so they still look like they belong together when they go back on.

If one part in a set is too far gone to restore, we can make a new one from a good one in the set. That new part is cut, drilled and finished to match the restored ones, so the set stays complete. We tell you which part it is and why before any work starts.

Metal parts restoration: questions

Something else on your mind? Call the shop at (775) 678-1312.

How do you remove rust and old finish?

Mechanically, with wire wheels, abrasive discs, belts, files and hand tools. That keeps the process simple, controlled and easy to stop at the right point.

Can you paint the parts after?

We hand the parts back clean and ready for your painter or your own finish, or with a brushed or satin bare metal surface.

Can a badly pitted part be restored?

Light and medium pitting usually cleans up well. Deep pitting may leave marks, and we show you before we go further.

Do you restore old castings?

We clean and dress castings by hand. If a casting is cracked, we look at it with you and talk through whether a copy is the better path.

Get help with metal parts restoration

Send the request with a short description of the part. We follow up during shop hours and ask for photos or drawings by email.